Posted by Dick2 on November 23, 2012 at 14:45:39 from (174.19.205.113):
In Reply to: Still no success. posted by JayinNY on November 23, 2012 at 14:05:10:
You hit on the answer to your question yourself. The nails work out from the expansion and contraction of the metal.
My brother had to spend a few days on my nephew's pole barns screwing the metal sheets down because nails were working out all over the buildings.
Our neohew can't stand heights, so my brother climbed and put in the screws on all the sheets that were coming loose. There shouldn't be anymore problems; I forgot how many pounds of screws that he put in, but it was a lot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
