Gonna offer a follow up comment then another possibility that may have been missed.
Someone reffered to a induction repulsion motor. I have always reffered to them as repulsion induction. ie Repulsion start Induction run. These were the best thing for hard starting loads. They were also high maintenance since they had brushes that needed to be replaced. They also haven't been made for thirty years or so. What you likely have is a split phase motor which are the worst for starting loads I didn't think these were made as big as 1 horse though. A capacitor start motor should be adequate.
Another suggestion, What ratio is set up in the drive. You said the motor is 1750 (no load of 1800). Should have at least a 3 to 1 ratio. No point in running a auger faster than 600 rpm as anything faster is just spinning your wheels. At least that is what my prof taught me at ISU.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.