Posted by jackinok on December 05, 2012 at 12:35:33 from (162.58.82.136):
In Reply to: truck eletric drain posted by OLarry from MD on December 05, 2012 at 09:13:53:
often how the dome interior lights works is they have power constantly,but no ground.door swtches and things supply the ground circuit. they do this simply because it requires much less wiring. it also a lot of times throws folks off when they are trying to check the circuits because you cant simply check from one side of bulb to the other with a meter when light is supposed to be on. if you have a bad switch for instance, trouble shooting by checking accross bulb socket with a meter will show nothing.check from one side of bulb to ground,if you show 12 volts there,and light is not working and bulb is good you have a bad switch normaly.there is a condition however where this type of circuit can cause a battery drain. that is if the switch or wire to switch has a high resistance short to ground constantly. this particular problem might not cause bulb to light,But it will bleed off power... and just fyi.. normal type 12volt bulb does pull about two amps. pull the bulbs from lights to check for this. bulbs themselves can act as fuses in the right conditions. and they will handle up to several amps before they burn up..other places to check,alternator,brake lights. I do not know if you have one, but a floor mounted light dimmer switch can cause weird problems also. rust dirt and things that get inside can cause high resistance shorts. and thats possibly your culprit if it has one.that would also be in the light circuit,and should stop when light fuse is pulled. i dont recall a auto circuit where dome and headlights are on the same circuit, but it is possible. normally they are seperate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
