I've never witnessed a case where ether damaged a gas engine in farm equipment. I suspect the compression is so low, the extra pressure from the ether seems to be pretty much harmless. Can say what happens with a car that might have 9 to 1 compression. I've never seen it needed.
As to the claims about ether not hurting diesels? I've seen plenty of diesels get ruined including many Deere 300-series that were direct-injected (NO glow plugs).
Anybody who claims otherwise I suspect never worked in a diesel repair shop in a cold-climate area.
Also about ether injection on factory equipped engines? Yes - and that injection system uses an injector orifice that limits overloading. Be it electric/solenoid injection or just a simple tube from the intake manifold - the factory installed units have limiting orifices.
My neighbor ruined the engine twice in one winter in his Deere 350. I'm the one that had to fix it twice and then told him "no more." A block heater would of saved him a lot of money. The first time he broke all his top rings and cracked one piston. The 2nd time -after being rebuilt he swore he'd use a block heater to start. Then one morning when it was below 0 out - his daughter got her car stuck in the barnyard. He needed his 350 in a hurry - and removed the air-cleaner cover and shot a bunch of ether in (again). This time he had two of the aftermarket pistons (Tisco) completely shatter to pieces. When I pulled the head there were two connecting rods with wrist pins - and no pistons. Just lots of pieces.
I've got an Allis Chalmers HD4 in my shop right now. The guy had a bad starter and weak batteries. His easy fix was to yank the air-cleaner bowl off and spray a lot of ether in there. He broke all the tops rings off of every piston. Still ran pretty good once hot but smoked and ate a lot of oil. And -impossible to start without a lot more ether.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.