Posted by Billy NY on December 14, 2012 at 17:28:26 from (24.29.79.122):
In Reply to: Sawing firewood. posted by JayinNY on December 14, 2012 at 16:48:13:
Its part of the game, stacking, stove size, making common sizes for sale etc.
I use the bar on the saw and narrow it in, 18" will easily work in my old Ashley HFR 25, but I prefer 16", so from a 20" bar including what is under the sprocket cover I walk along the log, eyeball 4" less, don't take my eye off that spot and put a mark with the saw.
I thought my friend had some kind of accessory on his saw that helps you mark out where you want to cut, I vaguely remember it, comes off the side I think, I just do the same with the bar.
I am very fortunate to be able to draw logs in from the land, our old farm, which is contiguous with the land my home is on, in the last few years I cut a bunch up from clean up, dying or dead trees, that '08 ice storm which I still have cords upon cords to get out of the woods, then there's the old woods, 11 acres on the highest point 650' above sea level, a ridge, whole bunch of leaners and similar which I avoid, going to take some time to think how to safely get those down. Went astray here, I'm just thankful for what I have when it comes firewood, me and a friend talk about it, cut quite a bit at his place east of here, and run our splitters etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.