Posted by Dr. Walt on December 18, 2012 at 04:32:08 from (12.2.223.79):
In Reply to: OT wash machine wars posted by charlie n on December 17, 2012 at 20:42:24:
Thirty years ago, I salvaged an old Maytag Wringer Washer at a property that I was cleaning up. It had originally been one that had the "kick-start" single cyl. gas motor on it, and someone had removed the gas motor presumably to convert it to an electric unit, but then never finished it. I took the electric motor off of another dead washer (rusted out tub) and rebuilt the Maytag and started using it. The spindle seal was worn out and caused it to leak badly.
As luck would have it, I just by chance met a gentleman that had been a Maytag Repairman his entire life and he had several of them. I GLADLY paid $10 each (I bought two) for a $2 rubber Spindle Cup-Seal (goes under the conical spindle cap)& bought whatever other parts that he had that I thought I might need(tub seal, discharge hose spigot w/ hook, etc.) and finished rebuilding the washer. IT WORKS GREAT! - Oh, my deep "twin-tub" rinse tub is enameled Cast Iron (HEAVY!). I haven't used either for many years - I'm spoiled by the modern "automatic" washers, but I still have them as back-ups.
Doc
P.S.: A short note of personal history - When I was 6 years old I got my fingers caught in the wringers on my mother's wringer washer. Gotta watch out for those rollers, especially the ones with the molded ribs on the rollers. - They're hungry & they love to eat fingers and it H U R T S !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
