Posted by George Marsh on December 27, 2012 at 08:38:20 from (205.188.116.74):
In Reply to: battery maintainers posted by mss3020 on December 27, 2012 at 07:32:37:
First thought it to get rid of the charger you have and any that are just like it.
Putting anything you think may catch on fire in a metal bucket is not a bad idea. Make a cord with a GFCI. The GFCI should trip is anything goes wrong and shorts to the bucket. May put a ground wire on the metal bucket. Perhaps a metal cover on the bucket and place the bucket on bricks.
What kind of maintainer are you using?
I have my mom's old electric wheelchair, with Ni-CD batteries. They discharge on their own. So I have a mechanical timer that turns the charger on for 30 minutes/day. Seems to keep them up.
I also use a timer on my dewalt charger. One hour is more than enough to charger a battery. That way I'm not cooking the battery.
It could be your battery causing the problem too. Try a timer and a smart charger. Juice the battery for 30 minutes or so a day.
Personally, I don't leave a trickle charger on 24/7.
I purchased a batteryminder 12248. Directions say to charge the battery and then let it sit for a few weeks or more. I rotate batteryminder to different batteries.
Santa is bringing me a battery conductivity meter. Hope to get it soon. This will tell me where the battery is in it's life cycle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.