Posted by buickanddeere on January 08, 2013 at 09:51:23 from (184.151.61.237):
In Reply to: OT 110 from 220 posted by old on January 08, 2013 at 08:38:07:
Quoting Removed, click Modern View to see
That is why the proper supply out to a remote panel is four wires and float the neutral bar.Problem we are stuck with a hang over from the early 1900's with a three wire overhead triplex supply.
The proper connection at a remote panel supplied with a triplex. Is a floating neutral bar connected to earth through a tingle voltage filter. Or if legal, float the neutral and run a proven working ground system with no neutral to earth bond.
The only reason neutral has a connection to earth is to keep the neutral at earth potential. And limit line touch voltage to a max of 120,240,277 or 600.
The ground bond to neutral which is only supposed to occur at the transformer and at the first panel depending. This is to limit the possible shock to earth to less than 120,240,277 or 347 V. Incase the service transformer fails .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
