Posted by TLZ on January 11, 2013 at 17:47:48 from (69.168.144.148):
In Reply to: Feeding Round Bales posted by bill in colo on January 11, 2013 at 14:35:14:
Ok i do this. Take the bale to where your going to feed it. Stand it on end, cut the twines as close as u can to the frozen spot as possible so you can then take all the strings on the bottom because they are not frozen and tie them into a knot, you can even tie it twice. This keeps all the twines together and u r never pulling on just one or two twines at a time but you can still pull one at a time and not have to worry about dropping any of the other ones. They all stay tied together. It works for me. When you do have 2-3 inches of ice melted on top and down the sides of the bale I sometime will peal the outsde layer off and tie the wad of strings to a tree, and the cows do the rest of cleaning them off leaving the twine behind. For sure u want to double knot it in this case. Long winded Todd
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.