1987 in Jan. we had lots of snow. Was working at Burlington Ind. Brookneal Va. in maintenance. This plant used steam and heated with steam. One gas boiler and 3 coal boilers that were installed in 1948. Boiler house is 5 stories high, coal fed in from the top by conveyors. No guard rail around the edge of the roof. Flat top roof with about a 2 ft. high edge.
Coal conveyor plugged up with frozen chunks of coal. About 16 deg. that night. Was 3 of us up there and used pry bars, shovels and big pipe wrench to get these plugs broken up and get the screw conveyor started again. One of my friends picked up the pipe wrench and got it on the shaft of the screw close to a hanger bearing. Slid a piece of pipe over the handle. He was standing between the conveyor and the edge of the roof, about 4 ft. between the two. I was standing in front of him with the pry bar facing him. Pipe wrench slipped off and he was headed to falling off the roof.I grabbed the shoulder of his coat and held with all I could. Both legs up to his knees went over the edge and I stopped him from the fall. Thought I was going over too till his body hit the roof.
We both had to go sit down for a little while to shake that feeling away. OSHA a few years later made the company put a guard fence around the edge of the roof. It was needed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.