Was not allowed to drive for 6 weeks and rehab did not start for a few weeks after. I could not do that tho as I had a torn rotator cuff that after 7 months the dr. decided I was well enough to go under the knife again. Was a full year before I felt like working again but that second surgery I am sure held me back. Think I had one about noon as I got real bad back pain for possibly 15 minuts and went away (A bone Dr. was treating me for back pain, since my heart atack I have not had the back pain) so I thought it was that. Then about 15 minuts after went to bed chest started hurting, took a few tums and thought that would take care of it, was not long till woke up wife and said I was heading to hospital. Had 2 that were over 95% blocked with 3 over 85% and where the blockages were they could not use the stents. 5 cuts in one leg and 4 in the other where they took veins. I was 67 when it was done and now am 69 so your age being younger may help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
