About the same situation here. Lots of dead ash. A thanksgiving ice storm a year ago broke the tops out of a lot of our sugar maples and the two wind storms last spring and fall uprouted about any species in the woods that was on bedrock where tap roots couldn't penetrate. The storms left our sugarbush in a mess. Lots of leaners "loaded" trees that can barber chair, or pull down another one when cut. We have to be very careful. The other day one of my younger cousins was going to saw off a 20" maple that was half ripped out of the ground and hung at about a 45* angle, lodged in another tree. He had no clue that the stump was wanting to fall back into the hole, or that the tree would split, lengthwise. I stopped him, through a chain around the body of the tree above the cut. I then cut off a couple of roots that my cousin was straddling, and made sure I had a path to retreat if something unexpected still happened After watchfully making a couple of under cuts, I continued his top cut. The stump slammed back in the hole. The but of the log fell to the ground, however it still had to be pulled out of the tree it was hung up in. My cousin had no clue that the stump was the danger in this situation. He learned something that day. Loren, the Acg.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
