I'm big on reloading; that eliminates the price of new ammo. I know; there is an initial cost of reloading equipment and supplies, bullets, powder and primers but once you have that stuff, you are pretty much set.
I'm almost 70 years old and I've had rifles since I was about 12 years old. My primary interest for years was woodchuck hunting here in the north east. We used kind of heavy, long barreled rifles with big scopes. ( still have my 14x Unertl target scope.) I'm not a "long barrel fan" any more.
I've used a .243., 22/250 .223 and 22 Hornet. If I had to go with just one caliber,it would be a 22/250. .243 is more than needed, 22 Hornet not enough for longer ranges, the.223 is darn good but I think that the 22/250 is at the top of the list. Just a little bit more to it than a .223.
I've had Remingtons and Savages. Twenty years ago, the Remingtons were the choice but today, one of the Savgge models in 22.250 would be hard to beat. No experience with Rugers.
That's my $.02 based on my years of experience; whatever you decide to do, enjoy!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
