Posted by RusselAZ on January 27, 2013 at 22:53:39 from (24.121.165.26):
In Reply to: Jayhawk Hay Stacker posted by NEED HELP! on January 27, 2013 at 15:24:08:
What would you like to know? My Dad had one that he used on the front of his M Farmall and I was lucky enough to spend many hours driving it. When he moved to town, he took it apart for the angle iron which was still at my Mom's place in 2006 when I sold the place in town. However I do have the hydraulic ram and carrier angles with it. Is the one you are looking at hydraulic or ground drive lift? His started out life as a ground drive, shoot just thought, I have some oak teeth for it also. Oh back to the drive, The ground drive took some planning to reach the stack at the right height without having to back up.
There is some limited information on the net and may be some book reprints for it. I may have his book someplace too.
After he got a baler we then used it to pick them up by pulling it behind the tractor between the rows of bales. A couple of husky teenagers on each side throwing the bales (one was ME)on the sweep head and then riding up to the top of the stack.
He had a nice 5 gallon add on tank that screwed into the pump reservoir on his M so there was enough oil to raise it to the top. Used it to re-roof the farm building as it would go way up there! Also hung beef and pigs on it to butcher. Was a pretty handy piece of equipment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
