Posted by GeneMO on February 02, 2013 at 20:47:25 from (71.1.106.8):
In Reply to: JD 7000 planter posted by Donm7540 on February 02, 2013 at 16:04:19:
I am assuming you dont have a monitor, we never did. But I know every inch of that planter.
If you want to check plant population or seed spacing to make sure it is working.
Set the depth adjustment as shallow as possible. You can basically make it plant on top of the ground. It will make a little slot, but not much.
Then, with maybe a pint or so of seed in the hopper, drive over a really hard spot of bare ground. Like out in the barn lot or somewhere.
Drive for 50 or 75 feet, drive at an even, slow speed. The corn will be laying right on the top of the ground. You can measure off ten feet, then take an average. Or measure off 1/1000 of an acre. 13.8 feet for 38" rows, etc. Most farm reference books will give you the distance for whatever row spacing.
So 19 kernals in 13.8 feet equals 19,000 plant population.
If there is no corn under one unit, you got a problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.