Posted by Greg1959 on February 17, 2013 at 19:17:37 from (69.176.13.178):
In Reply to: Re: unemployment posted by Spook on February 17, 2013 at 18:57:56:
I worked for a construction company like that for a couple of years. First, you went to the office to see where you were going to work for the day. Then each worker drove their own truck to the job site because you had to provide your own tools for anything you needed. We even had to pay for a Porta-Potty if we wanted one on the job site.
Had to pay our own workers comp. and SS withholdings and unemployment insurance (which was silly because--who would want to pay yourself for unemployment?
Staring pay was $10/hr then after the first year you went to $11/hr. The third year took you to $12/hr. and that was where the pay stopped.
It wound up costing me money to work there. Buying my own tools and gas to drive all over the state. No road time pay or paying for a hotel room/food.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
