Posted by ss55 on February 20, 2013 at 16:57:02 from (173.31.19.80):
In Reply to: How much? posted by tomturkey on February 20, 2013 at 05:20:39:
That is an interesting question! I can't answer your question directly because I don't know how much power is takes to run the sheller.
Summarizing from a recent reprint of "Case Steam Engine Manual":
4 gallons of water per Brake Horse Power developed per hour.
4.5 pounds of coal per Brake Horse Power developed per hour.
A cord of good hard maple or hickory wood = 1 ton of soft coal.
A cord of red or black oak = 1500 pounds of soft coal.
A cord of dry poplar or pine = 800 to 900 pounds of soft coal.
2.5 to 3 tons of dry straw = 1 ton of soft coal
2.5 tons of dry corn cobs = 1 ton of soft coal.
200 gallons of fuel oil = 1 ton of soft coal. (Does this sound accurate?) And 2 1/2 cents per gallon fuel oil = $5 per ton coal.
If that information is accurate:
A steam engine produceing 20 HP continuously at the pulley , or 25 HP on an 80 percent duty cycle (a big thresher?) would consume: 20 HP x 4 gallons water/HP-hr = 80 gallons of water per hour, and 20 HP x 4.5 lb coal/HP-hr = 90 pounds of coal per hour.
The scary part is: 90 pounds of coal per hour x (200 gallons fuel oil per 2000 pounds of coal) = 9 gallons of fuel oil per hour for that 20 HP. I knew the old steamers were inefficient but I didn't think they were that bad.
2000 pounds/ton soft coal / 4.5 pounds coal/HP-hr = 444.4 HP-hr per ton of soft coal.
If 200 gallons of fuel oil equals 1 ton of soft coal:
444.4 HP-hr / 200 gallons of fuel oil = 2.22 HP-hr per gallon of fuel oil.
Modern diesel tractors produce around 16 Hp-hr per gallon of diesel fuel. The term fuel oil may have meant distilate or tractor fuel (all fuel?) rather than todays furnace fuel oil.
Would anyone who runs a steam engine tell us if those figures are in the ball park?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.