Posted by JD Seller on February 28, 2013 at 17:03:10 from (208.126.196.144):
In Reply to: 7520 head posted by 4020 on February 28, 2013 at 10:20:34:
Not to be a smart butt but it may or may not. LOL I know that helps a lot.
Some of the 619 cylinder heads will interchange with the 531 head. The difference is in the age of the block and the age of the 619 head. The early JD 5010 block will not seal around the sleeve with the 619 head. The later JD 5020 and 7520 will seal around the cylinder head with the 619 head out of a 30 series age of engine. The newer 619 engines have a different relief around the valves and will not mate the earlier blocks.
This is from memory as I have not done this switch in over thirty years. We where doing it on some of the self propelled forage harvesters. I do remember we did it but had to have a certain cylinder heads for it to work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
