Posted by Dick2 on March 04, 2013 at 14:25:08 from (174.26.220.227):
In Reply to: case 310B posted by gracie01 on March 04, 2013 at 13:44:34:
Check with the local machine shops and see if they can repair the head, possibly using the "plug-on-plug method. It has become quite common for repairing cracks in cast iron.
We had a sand hole in a block repaired that way in 1950 and it is still holding. The guy who did the repair was a POW in Germany in WWII and they gave him a job sweeping floors in a factory that was making the plugs that were used to repair cracks in cast iron. He started his own machine shop after the war and imported plugs from that factory and used their method of repair.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
