Posted by Ralphwd45 on March 06, 2013 at 21:07:51 from (66.243.214.142):
In Reply to: Allis WD Hydorlics posted by Russ5099 on March 06, 2013 at 15:36:37:
I wanted to hang a 3pt, with down pressure on my CA which uses the same 4 piston pump that the WD does. Remember that you are dealing with a 3000 psi system, and cylinders should be rated the same! I used 2 short double acting cylinders, on the 3 pt, and hooked my in hose from my control valve with float, to the pressure port. My out hose from the control valve runs under the rear end to the hydraulic resivour fill plug.I need to take some time, and redo this connection( needs a Tee there, so I can add Hi Yran when needed. It works ok but is slower due to smaller flow of oil, in pressure outlet at the pump. It is still NOT live hydraulics, except when using the hand clutch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
