Posted by Bob Bancroft on March 16, 2013 at 12:46:24 from (97.73.64.152):
In Reply to: Knocked unconscious posted by rrlund on March 16, 2013 at 07:15:48:
Probably 10 years old. Sitting up on the edge of a gravity box watching/kicking oats into the little 4" auger setting in the wagon, going up through floor above center of drive through corn crib. I recall catching myself nodding off once or twice. Next thing I know I'm waking up, laying on my side, on the ground. Auger is rattling empty. I roll over on my back, and I'm looking up at the steel wagon tongue. Actually had to move quite a bit to get out from under tongue. I climb back up and go to work, just in time to see my cousin come down from overhead, thinking the wagon was empty. It would have been a lot less of a fall to fall forward. But I would have ended up in the auger. I never felt a thing. No soreness later. Anybody believe in angels?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.