Take a look at rotational grazing supplies at Kencove. Here is what I do.
I have a 6 wire 12.5ga high tensile perimeter fence. For internal fencing, I use some white 1/8in plastic rope wire that has stainless wires embedded. I put a step-in pigtail that has a white plastic insulator on top. Spaced 20 paces apart. I hook them to the perimeter fence on both sides with an insulator hook on one side and a gate hook that passes the electric on the other. Stays just as hot as the permanent fence and can be moved or removed in minutes. I use a orange electrical cord roll-up (cost about 7 bucks in any home center) to roll up the wire when not in use. I use these all summer and have never had a adult cow go thru it. The calves will sometimes go under it but they tend to stay pretty close to mama so not a problem. As the get older they respect it more. My fencer puts out 18K volts on the meter in the barn (Parmak SE4) and my portable meter usually shows about 8-9Kvolts at any point on the fence. The rolls of rope wire are made by many companies. The Gallager brand seems to hold up the best. I replace it every 3-4 years as it can age in the sun. A new roll of a couple thousand feet costs about 30 bucks.
No way I would be pounding in t-Posts...or removing them, on a temporary internal fence. A single really hot wire will keep them in...
Makes it really easy to remove it all if I have to cut hay or reseed. I also remove it all when in winter and the cows are in the dry lot.
John
This post was edited by Hogleg at 06:09:11 03/23/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
