Common thing near here, as soon as I hear the rotor wash of a Bell UH1, theres a good chance its NYSP, and or a bank robbery nearby, now since 2009, its happened at least 4 times, I think 5 since yesterday. Darned thing always flies right over my house, not as bad as the incident last fall whereas there was an escape from custody, that was covered up by an alleged gasoline theft from the local convenience store, just loved that one, some fool potentially in the woods and another helicopter different model, just buzzing the treetops for 2 hours. 2 robberies in a few days, same suspect they think.
I just hate when they send air support up, because you never know what the heck is going on, the one last fall was interesting, spring of '09, was following the grain drill and cultipacking, bank was robbed, that UH1 hovered directly over me, I poked my head out from under the JD3150 and looked up at them. Its hard to figure whats up, is there a bad guy on the ground, were they checking on me to see if I was the guy or he had me held up or something, never a dull moment anymore, years back bank robberies were relatively unheard of around here, I know as I lived next to NYSP barracks, we used to know what was going on, not any more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
