Posted by KEH on April 08, 2013 at 18:21:52 from (209.213.19.196):
Didn't read the postings yesterday so the thread about hay stacks is way down the pages, so I'll do a new thread.
To make a hay stack with pole in center: I've helped Daddy make them in earler days. I guess the purpose of the pole in the center is to make a more uniform stack to shed water. I'm in SC where it rains(usually). Keeping hay from spoiling in the dry states has to be easier.
We would first dig a shallow hole since we didn't have a post hole digger until later and set the pole in it. Pole didn't have to be deep in the ground since the hay was going to support it. Scrap lumber or tree limbs were then laid on the ground in about a 12 foot circle.Purpose was to keep the hay off the ground. Hay was pitched on the lumber, taking care to keep it in a more or less circle and walking around on it to pack it down to make best use of the space and to better shed water. The diameter of the stack was steadily decreased as the stack grew taller until at the top there was barely space to walk around. The pole had been sharpened at the top and Daddy would, at the last, take a big fork full of hay and force it over the sharp end of the pole. This was called capping the stack and the purpose was to keep water from going into the stack around the pole. A properly made stack would preserve hay better than a round bale sitting on the ground.
When time came to feed the hay, hay was taken off the top. Sometimes a piece of canvas was put at the top after feeding started to shed water off the opened stack.
As I recall, hay stacks didn't last too well after the first year. Nobody that I recall made round piles without the pole in the center.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
