Posted by JD Seller on April 13, 2013 at 17:06:34 from (208.126.196.144):
In Reply to: The search continues posted by flying belgian on April 13, 2013 at 16:25:59:
My father used to have Ford F900 dump trucks with the 534 motors in them. They would dust the Cummins 350 horse power diesels on just about any type of pull. So that truck has problems.
Also when they where running correctly but pulling hard they would get 2 to 2 1/2 miles per gallon. That is correct real hard pull 2 MPG!!!! That is why NO body will buy the things other than as a collector piece.
When Dad bought his first one gas was 37 cents per gallon in 1972. So think about what they would be like with $3.90 gas???? You could hire your grain hauled for what they would cost to run.
I had a Chev C60 tandem with a 366 gas motor and a 13 speed. I sold it ten years ago because it would average 3-4 MPG when hauling grain. I could hire it hauled cheaper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
