My father also "pinched pennies" which caused us countless in-season delays and stress. Mother claimed both he and his father managed using the same philosophy: "if you don't spend much money than you don't have to make as much". Works to a certain extent but can result in a miserable existance. Major problem was that neither were mechanics. Grandfather clung to horses and when tractors arrived he had enough resources to hire things repaired. Consequently Dad never had to work on mechanical stuff. Fine for my relatively wealthy grandfather, but doesn't work very well when the money didn't pass down hill. So rather than pay for preventive maintenance, we typically patched stuff together with bailing wire and suffered the consequences. Later my brother went to a mechanics school and became a good mechanic, but when working on home projects continued to follow the don't spend much philosophy. No doubt he improved the farm's profitability but stress level was still too high. In contrast he believes I spend money too wildly. My approach was to continue my education and thereby get a good paying job. This has allowed me to afford some "extravagance" which although might lower farm's profit, certainly contributes to a lot less stress and enhances the farming experience.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.