Posted by B-maniac on April 22, 2013 at 14:00:10 from (97.85.59.154):
In Reply to: Re: John Deere B Clutch posted by Retired Farmer on April 22, 2013 at 12:04:10:
In order to make sure the adj plate is perfectly parrallel to the driver it works best to tighten all three all the way until just tight. Then back them off 1/4 turn at a time until you can release and snap it in. Then keep on going until you cant get a snap anymore and then start back in until it requires about a 5-10 lb push to snap it in and back out. It only needs enough to over center the dogs. Now it is not only adjusted right to snap but also parrallel to the driver so no grabbing. After initial tightening , everything is done 1/4 turn at a time. Don't worry if the keyway is a hair off at the end, it won't be over a 1/16th of a turn to get it in. Also a nice little trick to really smooth out engagement is to install a stiff spring washer on each stud before the nut.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
