Posted by Nick Ropke on May 01, 2013 at 14:58:50 from (216.124.141.231):
I have a 51 farmall M that I was wanting to put on a john deere 2008 15ft batwing mower as our jd 5625 is currently on the ditcher, my M has enough power to run the mower but when went to lift the mower when it was folded up I blew a line on my tractor. the lines where old and weathered so I needed to replace them any ways but my question is this, if I put a new line on my tractor will the belly pump have enough pressure to rase the mower? the mower has about 1.5in cylinders on it and ways roughly 3500-5000lbs. I ended up using another tractor to lower and unfold the mower and the m has plenty of power to run it and I added a 4.5 gallon ressivor a year ago to run an auger I have a plane belly pump on this tractor that is currently set up for a two way system thanks for any helpful information
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.