I think I would have it pumped soon, if for no other reason, peace of mind. 17 years is a pretty long time, it doesn"t cost THAT much to have a tank pumped, and then you wouldn"t have to be concerned about it again for a long time.
If you know just where the septic tank is, it will probably save you quite a bit of money if you dig enough to be able to open the lids. Most septic tank pumpers will do the digging, but they sure don"t like it much and charge accordingly.
Most fairly modern tanks have two chambers, with the second chamber designed to catch any overflow of solids from the main chamber, rather than letting the solids pass out of the tank and plug up the drainfield. So you probably need to dig enough to open both large lids, so the pumper can empty both chambers. When I have had my septic tank pumped, usually about every 10 years, there was several feet of ashy looking solids in the main chamber, but almost nothing but liquid in the second chamber.
Have I ever had any problems with my septic tank or drainfield? No, but we do try to not add excessive solids to the tank and do have it pumped every few years.
It is a heck of a lot cheaper to have a septic tank pumped once in awhile than it is to have to replace a drainfield. And with the more recent regulations that have been passed in the 35 years since I put this system in, I might have to do a much more elaborate and expensive system. Those newer systems usually involve pressure mounds, electric pumps and lots more cost. My current system works by gravity, which is free and always there.
I would get the job done ASAP, and hope it is in time. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.