Re: cub cadet cluth for mowing belt
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by Bill on June 24, 1998 at 05:24:45:
In Reply to: cub cadet cluth for mowing belt posted by charlie on June 24, 1998 at 01:19:46:
If you are asking about the front clutch removal; it
is held on to the bearing with set-screws that are
in the 3 holes in the cast iron portion of the clutch.
There are also 3 cut-out areas in the outside hub
that need to be lined up with these 3 holes. Then
using an allen wrench, remove 2 set-screws from each
hole. You need to probably get a new clutch disk,
new anti-rattle springs (3), and a new button for
release lever in front. This could be the cause of
your clutch failure. If the button fails and is not
replaced, it will damage the pressure plate button and
the spring plates. This can all be done through the
front grille. Good luck! Bill
: I have a 1968 cub cadet i think the cluth that operates the mowing deck quit working can anyone tell me how to to remove it?
Follow Ups:
Post a Followup
|
