Thanks for the concern Lady! Knock on wood, where I live, NE of Dallas is usually pretty quiet. We miss a lot of rain but we usually also miss the big hail and wind storms.
Texas likes a big block buster every once in awhile. Years ago a twister hit the Great Plains Life building in Lubbock; single sky scraper in town. It was a 30ish story building but was rectangular; like a city block long but 1/4 block wide. The twister "twisted" the steel and brick building like you'd twist a piece of candy. Last I knew was still unoccupied.
Dallas gets one every once in awhile but does little damage.
Waco which is SW of dallas had a bad one back in '56 as I recall. Went through down town and tore up some things.
West/West Central TX. gets most of them. Granbury is on the east end of that rocky, desolate (but beautiful to the beholder), barren except for a few Mesquite trees (great B-BQ wood) land, and they get whacked occasionally. For a (reported) mile wide tornado to hit that place is really odd, and to have 12 (reported) tornadoes out of one front, multiple little intense cells, is most unusual.
The good news is that I had to plant my hay crop late as Pearl Millet has to have 65F average soil temp. It has been trying to germinate for the past several weeks and not much happening. The WF said we got between 1 and 2" which should get it on it's way. I'm thrilled as had this one not come I was looking at having to re-plant.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
