Posted by Texasmark1 on May 20, 2013 at 13:41:09 from (172.242.14.126):
In Reply to: Sickle mowers posted by Chuck one on May 20, 2013 at 11:01:54:
Couple of problems covered. Other thing is they gum up with crawdad mounds, fire ant hills, are a pain to remove the cutter bar when necessary, when in the stow position stick up in the air vertically where you can unsuspectingly derive under a low handing limb and break the whole gearbox into several pieces.
On tough grasses they just chew on it especially if the blades aren't new and properly adjusted.
Then there is the pain in the .....in trying to mount one on the tractor since it is lopsided.
If you have any little saplings under those trees they will just put you in the kickback mode and you have to stop and reset the bar.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
