Posted by JD Seller on May 21, 2013 at 20:10:36 from (208.126.196.144):
Here is some pictures I took around the farm this afternoon.
Some of the first corn we planted on Sunday afternoon May 12th. So it has been in the ground just 9 days. This is in bean stubble. The ground worked real mellow and great moisture.
This corn was planted May 14 around noon. It is corn on corn. It has only been in the ground one week. I think that is pretty good growth.
This is one of the fields of Rye Grass I am going to bale for hay. It really has grown this last two weeks. It is heading out so we just started mowing it today.
Here is some of the rye in the windrow. It is going to make quite a few bales.
Here is some of the fence I built this spring. This is five strands of barbed wire with wooden post on all the corners. Every other post in the line wood and then steel. Makes a good cattle tight fence.
Here is one of the steepest contours we farm. You really pull a tractor climbing up out of the bottom of this water way. This rye in where I feed some of my beef cattle out side all winter. This was corn last fall and then we chopped it. I then sowed rye on it for a cover and spring forage. The cold spring really held it back. I will plant this field back to corn. It is only a few hundred feet from the one silo. Plus the bottom ground in this field has top soil 3-4 feet thick. We tiled it years ago and rarely got below the top soil. So I manure the heck out of it and pretty much raise continuous corn on it.
We did some stand counts this afternoon too. Most where in the 34,000-35,000 live plants per acre. This is right where I want it to be on my good ground. We have a good start on a real good corn crop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.