Posted by donjr on May 23, 2013 at 13:03:19 from (72.71.178.69):
In Reply to: Planter Parts posted by Sparktrician on May 23, 2013 at 11:38:08:
If it's the Kinze unit that looks like the Deere 7000 series, your closing wheels and furrow openers should work just fine. Pay attention to your depthe control- about 2". As far as the no-til feature, that's the work of the no-til coulters on the front of the unit. Some are unit mounted, and some are frame mounted. Most of the Kinze units have a Yetter no-til coulter, which is slightly different than the Deere coulter- the bolt holes are different by about 1/16" and will not accept the JD no-til coulter, even though they look the same. The NI-Kinze I had was also maxed out at about 28,000 population if I remember right.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
