Posted by Paul on May 30, 2013 at 10:33:58 from (66.60.223.232):
In Reply to: Furnace fuel posted by 37Chief on May 29, 2013 at 22:42:33:
There is #1 and #2 fuel oil.
1 is refined more, thinner, and doesn't gel until 60 below or so.
2 is less refined, thicker, better for a hot working engine, more btu per gallon, cheaper, and starts to gel below freezing.
If they add a package of lubricity and other additives, it becomes diesel fuel. Sometimes heating oil does not have the additive package.
Typically, most places, they do not carry 4 products, because it becomes too expensive to keep that many different inventoried products.
They just carry #1 diesel, and #2 diesel. It gets sold as either diesel fuel or heating fuel. Same thing.
Typically you can take old heating fuel, which most often actually is diesel fuel, and use it in an older, sulfur accepting diesel tractor. If you are worried about the additives missing, blending the old fuel with new fuel 50-50 should take care of it and won't bother an old Diesel engine at all.
We can't assume the heating fuel will be either #1 or #2 grade, but either will work as a tractor fuel, ESP if you blend it with good fuel. In cold climates like mine, typically winter diesel or winter heating fuel is a blend of the 2 grades of fuel, so the gel point gets down to minus 20 or so.
I would hesitate to use it in a very modern Diesel engine, with their very close tolerances, high pressures, and pollution control features that do not like sulfur. I think that might not be a good idea.
After testing it a bit for burning, and keeping any rust or water on the bottom of the old tank from getting mixed in, I would easily use it in my old 1970s diesel tractors and not worry about it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.