Posted by John T on June 02, 2013 at 08:01:11 from (216.249.76.176):
In Reply to: OT Golf Cars posted by super99 on June 02, 2013 at 05:47:05:
I go to several large shows where I might cover SEVERAL MILES and use the cart FOUR OR MORE HOURS PER DAY (and lots of starts n stops).......THE ONLYYYYYYYYYY CART THAT WILL COME NEAR ALL THAT MANY MILES AND HOURS PER DAY USE WITH ALL THE STARTS N STOPS IS A GAS.
If youre at say the Florida Flywheelers all day with 4 grown men riding with a lot of starts n stop in that sand !!!!!!! Give me a break NO WAY AN ELECTRIC CART would last all day and all those miles.
If his is overheating or only good for short trips or short times HIS HAS A PROBLEM. Mines an old 1995 Yamaha Gas and I can use it all day for miles n miles and it NEVER gets hot or has a problem.
THAT BEING SAID if you have a newer 48 volt electric cart they can indeed last longer but of course until I run out of gas, theres no way they can go the miles n miles n hours n hours I can go WELL DUH
I use mine in the summer to run the pasture n check fence etc and drive up the road to the neighbors (plus grandkids drive it a ton) and 5 gallons of gas will last seems like half the summer.
So an elec is fine for whats it can do, but if you wanna run all day n miles n miles n miles with lots of starts n stops an elec will eventually run down its batteries while I can still keep going maybe 10 times as much or more till I run out of gas ITS A NO BRAINER IF YOU NEED HOURS OF USE PER DAY N LOTS OF MILES YOU NEED A GAS CART
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
