If I took a drive, the vast majority of the roofs will have the screws in the rib. That's the way it's done around here. What gives you the right to be such an arrogant a$$. I don't really give a crap if you've been at it for 30 years. I have both and everything screwed on the flat (previous owner) leaks. Certainly not all of them, but way worse than anything that's screwed on the rib(0 leaks). The OP said standard pole barn metal. To me that says Vic West Barnmaster 5 round-1/2" ribs. It does not dent the tin, and the washer does seat. I've just looked at 3 PDF files from Vic West, and NONE of them said how to screw the steel down. It did however call the ribs "nailing ribs" and later said to never use nails, only screws. It also showed alot more pictures of screws through the ribs. Let logic take over for a minute. If putting nails on the flat resulted in leaks, but putting them on the ribs all but eliminated leaks, does it not seem logical that screws would follow the same principle?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
