Posted by James22 on June 20, 2013 at 08:31:02 from (207.179.239.94):
In Reply to: fence paint posted by Tom Durrer on June 19, 2013 at 19:38:28:
No paint expert by a long shot, but just painted the floor in storage area we built inside the new shed. It was an oil based paint and the dealer said to cut it approximately 50% with paint thinner for the first coat. This soaks into the wood and provides better "tooth" for the top coat. Said not to use a primer with the new paints. Also said not to walk on the final coat for several days to allow it to fully dry. Waited 4 days after the thinned painting to roll on the top coat and only yesterday walked on it with sock feet to remove masking tape. Going to wait a few more days before putting stuff inside and really test it. Paint wasn't cheap, approx $40 gallon.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
