Let's try this again!!! If the tractor the JD 260 came off of is a JD row crop tractor under 150 hp then it will bolt right on. They all have 19 1/2 inch wide frame rails. I am not going to list the 30-40 models that would work. Example: JD 4440, bolt right on. JD 4640 would not work, the frame rails are wider on the 4640. Note the JD 4640 is over 150 HP.
Also the larger utility tractors ( JD 2840,JD 2940, JD 2959,JD 2955, JD 3055, JD 3155, etc) had side frames and the same width frame as the row crop tractor. The utility tractor just needed an axle support that went under the back axle. That support will work on the JD 4010 but it will be about 1 inch too low back at the axle. All you need is a piece of flat stock an inch thick with two holes drilled in it. Then just use longer axle clamp bolts.
So We really need to know WHAT THE LOADER IS ON NOW!!! John Deere made brackets to put a JD 260 loader on more then 50-60 models of tractors. Some will work and some will not.
I am not trying to be a smart butt here but I can tell you in under a minute talking if the loader will work. Posting I am guessing what the HECK the loader is on now. So I have ZERO IDEA if it will fit. NOT ENOUGH information. So post what the loader is currently on or what it came off of. Even better email me. I will send you my phone number. We can talk it out in just seconds on the phone. I am already tired of typing about it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
