Posted by Mark-Mi on July 05, 2013 at 20:01:53 from (68.66.31.18):
In Reply to: grease guns posted by Nancy Howell on July 05, 2013 at 07:51:32:
Yes I to am looking for the holy grail of grease guns. I have the heavy duty Lincoln and some Alemites. I had a old black pistol grip that worked great, you squeezed the front part of the grip instead of the back part like new guns but it plum wore out. My problem with new grease guns is the follower seal letting grease bypass. Could the cardboard cartridges be thinner these days? Sometimes a 1/4 to a 1/3 of the tube will bypass and what a mess when it is time to reload. And no I am not going to be bothered with locking the follower back when not in use. New guns will not push up thick grease(wimpy spring)? And thinner grease I have used like Lucas Red & Tacky goes by the seal. So I have had the best luck experimenting with different greases till I found one thick enough to not run by the junk seal and thin enough for the junk spring to push it up. And no I do not want a electric gun. I want to feel the pressure start to build in a bearing so I do not blow out the seal. Just refill the bearing. Sometimes I count the strokes and give each the same. If you can't tell by now grease guns are my pet peeve. I do not believe a good grease gun is built today. But I keep hoping someone will build a good one again. Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.