Respectfully speaking, that's a pretty broad statement. If it works good before surgery, there's a good chance of it working after surgery, providing you go to a competent surgeon. Don't mistake this for criticism - I'm glad the method you chose is working well for you.
You'll get lots of biased opinions about prostate procedures on a tractor website. These opinions will give you ideas to check out. Do your own research. Folks are saying that a surgeon is only interested in removal, but each specialist is gonna market his own specialty. Write down a big list of questions to ask each specialist. The questions that you should be asking are easily found with an internet search. To the original poster - I'm saying "you" but referring to your friend.
As far as incontinence - it is NOT a certainty that you'll have that problem after prostate removal.
For the record - I had prostate removal surgery (can't spell the proper word) two years ago. If I could do it over, I wouldn't change a thing.
I'm glad to see that this discussion has not gotten out of hand. This is a common problem for men, and one that should be peacefully and openly discussed, but maybe the moderators are wishing, "Not here."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
