Posted by John A. on July 11, 2013 at 06:27:25 from (64.128.16.238):
In Reply to: LPG Tractors/Pumps posted by newfarmer9 on July 10, 2013 at 20:38:45:
newfarmer9, Filling an LP Tank is Not Complicated at all..... IF You want to spend your hard earned money and buy a pump of some kind Go Ahead! BUT,!!!!!It is not Necessary! Remember Back in High School/ College Chemistry Class,.....You Studied the Principal a liquid moving from an area of High Concentration to an area of Low Concentration.......? Filling an LP Tank is the same Thing. With a Single Nurse Hose from the Bulk tank to the work tank. High Concentration of volume of liquid,and pressure ---> to ---> Low Concentration of volume of liquid,and pressure. Bulk Tank "Must" have a liquid line! Connect your hose to both tanks. Open Bleed valve on the Work tank (tractor, Pickup, BBQ etc,etc). If the work tank has a Vapor Return there is a Bleeder valve that can be used to help drop the pressure in the tank too. When the pressure drops to a given point the pressure in the Nurse tank will push the liquid LP into the Work tank. When the work tank reaches 85% full, there abouts, liquid will start escaping out... Remove the valve in the Vapor return, Close bleed valve Remove hose from the work tank and go on your way If you would like to visit Call Me if you like. My # 512-577-3837 Hope this helps. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
