Folks that complain about the existence of CRP and NRCS programs should brush up on their history of the 1930's, and look at what can happen when every inch of available land goes under the plow. I'm for limited federal govt., but I also don't have a problem with programs that provide incentive to maintain a cover crop or pasture on some of the land, so we don't have another dust bowl. Especially now when a lot of farmers are digging up their backyards to get as much tillable as possible, while at the same time areas of the country are in extended heat and drought. I'd rather have my tax dollar go to stewardship of our land, preserving the topsoil from being blown across the country, than spend another dime in Afghanistan.
In this specific case, I guess if it were me I wouldn't jump on their deal without looking at all the options. 10 years is a long time, if you plan on needing the land eventually. Why don't you look at maybe just doing a 1/3 or some smaller amount as CRP?
I had 4 acres in CRP that I pulled out last year that I'm going to fence off for pasture, but I'm looking at putting another 4 acres in next year. Small amount I know, but I hate watching that topsoil wash down the hill year after year.
I have 6 acres of tillable in an NRCS rotational grazing program. They paid for the seed, high tensile fence, and waterline to convert part of the corn base ground to pasture. Yeah, I have to play by their rules by keeping records of herd movement and forage height for 3 years, and they pay something around $40/acre. But in the process I'm learning a different way to farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.