toadady, Land can not be sold where it is land locked. There has to be a legal in and out to any given property! Where is his Easement? You said his place was sold off of yours many yrs ago before you got the place. That Said... If you sold it to him you would know where it is. Then...His Deed and Your Deed should give a description of the Meet and Bounds of that Easement! and then you will know where it is on your place. It is possible the Easement is on an adjoining place. If that Easement is on you, You can't stop him from Ingress or Regress to his property. Land that is on or along and old road that simply cut through other properties but for some reason due to no ownership change might still be that way can petition the court and prove that it was there for many yrs prior. My dad had to Prove and easement on a road, Non-Public that went back to the 1900s in 1980 cost him about $20,000 before it was all said and done! Any way Your Deed and His Deed and Platte Map will shed a great deal of light on this subject. A Land Measuring Chain and pins or a Wheel to measure with will help you determine the corners of your place. and the 2 or 3 points that are the same as yours. start from Known points that are easy to find. Who put the fence there is not the Question! The Question is Where is his Easement??? You have to get this ??? figured out first before any work can be done and know what is correct and true! Hope this helps!! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
