Posted by eamay on July 30, 2013 at 19:13:11 from (184.20.55.20):
93 year old neighbor just bought a vermeer 504 F, that has not baled much hay. But, it has set for several years. When engaging the pto the belts do not turn, and appear to not have enough tension on them. The tension cylinder in the middle of the baler has not hydraulic lines leading to it, but has lines connected to itself. The cylinder lacks about and inch or little more bottoming out on the stop. How do you add tension to the belts. The baler manual is one of the poorest manuals I have ever run across. Schematic shows lines going to the hydraulic tension system, but there are not lines that I can see. What am I missing? Would appreciate knowing how to get tension on these belts, they just sit while everything turns. All rollers seem to be operating normally. I have only run John Deere equipment, and I am not familiar with the yellow breed of baler. Thanks for any help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.