Posted by CharlieNJ on August 05, 2013 at 04:08:03 from (76.117.68.151):
In Reply to: Funeral plans??? posted by JD Seller on August 04, 2013 at 12:45:24:
JD, first, thank you for you service. Second I hope you are in good health, and will be around for quite some time, because you are an asset and an obvious favorite on this forum. That said, I have always held the opinion that the funeral service is for the living, not the deceased, so keep that in mind. My father's, USN WWII, flag is in my possession and I consider that an honor. He did not want or have a military funeral. I have attended funerals with the 21 gun salute, which is pretty moving, but I am partial to a live playing of "Taps" to conclude a veteran's service. I also disagree with the opinion stated that Vietnam was a waste. Granted, our exit from there was a disgrace. We were on the right side of that fight, and if it prevented the spread of communism for even one day, it was a noble cause. Best Regards, Charlie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
