Posted by Mark Robke on September 20, 2013 at 17:20:14 from (98.19.74.227):
In Reply to: Tractors too big posted by charlie M on September 19, 2013 at 17:56:30:
My Dad and uncle quit horses and started after WWII with an 8n Ford in 1948. They also bought a 50t engine drive baler(very heavy), and were afraid to pull it so they borrowed a neighbor's farmall H or M to pull it. One day they decided to try the ford and it was ok. Then they bought a 1950 8n also. Then they traded the '48 for a 52 8n (slightly more horse power). Then traded the 50 8n for jubile with a loader. In 1956 they traded the jubile for a 300 utility with a loader. Dad said, at first, they thought maybe the 300 was too big, but later learned, you can not have enough power. Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.