Posted by JD Seller on October 06, 2013 at 06:48:16 from (208.126.196.144):
In Reply to: hyd. couplers posted by hrross on October 05, 2013 at 22:18:30:
You hook them up and then turn the lever to open the fittings. The lever type are really nice to use as you do not have to worry about there being pressure on the lines/tips. You may have had the levers in the wrong position. You can usually feel the lever open the tips.
Also are you sure you have hydraulic pressure to the remotes??? You said this tractor needed some repairs. I would check and see if you have pressure at the SCV couplers.
Your disk and Tractor are both new enough that the tips should be the same. Some of the earlier tractors had to have the square tip on the Pioneer fitting. They would not work with the ball tip that most Pioneer tips have.
I would suspect that you have something going on with the tractor in front of the couplers. The couplers are pretty simple. I am not familiar with the SCV controls on that model of tractor. Could they be set to supper low flow or even off???
I had this happen a few times when JD switched SCV controls on the 7000 and 6000 tractors. The old flow control valve only turned about 270 degrees in total. The newer ones can turn 8-10 turns. You can fine tune the flow in real fine increments. So some of them got shipped with the flow turn all the way down. The new owner would turn it the 3/4 turn open and then had low flow or so little flow they thought they had zero flow. Cost me a 50 miles service call the first time I ran into it.
So maybe someone with a CIH 9150 will post on how the flow controls work on your CIH 9150. It may just be a setting that is wrong.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
