Posted by fixerupper on October 09, 2013 at 06:59:43 from (100.42.83.15):
In Reply to: Tiling Question posted by Bob in SD on October 09, 2013 at 06:27:42:
Quoting Removed, click Modern View to see
Go ahead and let them run it through as long as it's a big enough tile to handle everything that's upstream. If it's undersized for the anticipated flow your wet spot will be wetter. We have a drainage ditch going through our farm. A tile running from the neighbor's land went across our land to the drainage ditch and this tile was grossly overloaded in wet years, making our land wetter than it already was in that location. One July the neighbor came to us asking if he could run a bigger tile to the drainage ditch parallel to the overloaded one across our land and he would pay for the crop damage since this was in the summer. We agreed to it and now that the bigger tile is there our land has never been wet since then in that area. In fact, it's some of the best land on the farm now. By the way, we take any money for the crop damage because we knew it would improve our land. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
