Posted by dr sportster on October 15, 2013 at 19:10:14 from (68.195.44.249):
In Reply to: Solid vs stranded wire posted by gene Davis (Ga.) on October 15, 2013 at 17:54:06:
In a comparision of ampacity of large condutors [which are all stranded] a 500 kcmil cable can carry 430 amps yet a welding cable 500 kcmil can carry 695 amps. Cost is way higher but when you need the flexibilty for something like tapping conductors into an old box stuffed with wires the flexibility becomes a factor .Welding cable can be layed into the box where 500s of normal cable would not allow the cover to go back on . For a trough pull box etc. sometimes you have to get the expensive welding cable to close things up. You will have bloody knuckles trying to work with normal cable forget about solid.For something like generator lead to temp power up a building welding cable is the only way you can wrap them up like a small cord and place them back in the generator . For pools solid #8 must be used to equalize the potential of any metal part larger than 4 square inches. But does not have to be run back to the panel.Stranded will fail inspection. Solid conductors are usually only going to be 10s and 12 awg sizes[excepting swimming pool 8awg s]. Years ago solid was speced out more but I have not seen that for a good while. Solid has more chance of being nicked on any sharp edge when pulling a bunch through pipe. Like I said all large conductors are stranded. Unless you order solid the supply house is sending stranded. I have not seen solid larger than #8 that I can remmeber offhand. To use anything but stranded on a vehicle is probably bad practice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
